2.2 Item list
For the item list number the geometry data like exact width, height and length as well optional criteria from a list of attributes like name, group, sub group etc. can be used to compare the components.
Components, which have the same over- and rounding values, are getting combined to one item list position number, if desired and setup in the item list calculation settings. The same position number gets assigned as long the optional comparing criteria selected from list of attributes are identical as well.
Below the same components which got used for production list number, but showing calculated item list numbers.
Item list number
This position number is intended to be used for stock management or procurement purposes at the start of the project.
The item list numbers does not consider any geometry differences due to processes like cuts, drillings, end-types etc.